Laminated Products Board, tube and machined parts made to your drawing
Laminated products are finished parts cut and machined from insulating pressboard and laminated sheet: barrier rings, winding cylinders, clamps, spacers, lead supports and terminal boards. They are ordered by drawing rather than by sheet size.
- Pressboard thickness
- 0.5–8.0 mm
- Density
- 1.10–1.25 g/cm³
- Breakdown in oil
- ≥50 kV/mm
- Sheet size
- 1 m × 2 m, cut to size
Machined part range
Parts are made from oil-impregnated pressboard, 3240 epoxy glass board or phenolic laminate. The grade is chosen from the drawing and the service condition, then quoted as a finished part.
Selecting and specifying Laminated Products
- Send a drawing with the critical dimensions marked. Say which dimension you will inspect — wall thickness, hole position or concentricity — because that decides the machining step and the tolerance we quote.
- Name the material grade. Oil-impregnated pressboard 0.5–8.0 mm for oil barriers, 3240 epoxy glass board up to 120 mm for structural parts, phenolic 3025 where cost matters more than temperature.
- Confirm the machining route. Bandsaw blank, turned cylinder, milled slot, drilled hole, or an assembly bonded from several pieces where the section is too thick to machine from one block.
- Agree the first-article step. Dimension report against the drawing, material certificate for the grade, and the test items written on the drawing before the batch runs.
From part drawing to batch delivery
-
01
Send your specification
Thickness, width, quantity, thermal class and the drawing or standard you work to.
-
02
Material grade taken from the drawing
Grade and thickness chosen from the service condition on your drawing, with the machining allowance stated.
-
03
First article approved
The first machined part is measured against the drawing before the rest of the batch is cut.
-
04
Production and batch test
Batch run, test report and packing confirmed against the order before dispatch.
Laminated product questions
Do you machine parts to a customer drawing?
Yes. Send the drawing as DXF or PDF with a tolerance block; parts are cut, turned, milled and drilled from pressboard or laminated sheet and checked against the drawing before shipment.
Which material is used for oil-immersed transformer barriers?
Oil-impregnated pressboard: 0.5–8.0 mm thick, density 1.10–1.25 g/cm³ and ≥50 kV/mm breakdown in oil, cut from 1 m × 2 m sheet to the part outline.
How is a winding cylinder specified?
By inner diameter, wall thickness, length and pressboard grade. Send the finished size and we confirm the wall and length that can be held, then quote the part rather than the sheet.
Have a part drawing ready to quote?
Send the DXF or PDF with the tolerance block and the service condition. We reply with the grade, the machining route and a part price.
