Bendable composites · DMD / NMN / NHN / PMP · 0.05–0.50 mm

Insulation Flexible Laminates Bendable composites for slot liners and layer insulation

Flexible laminates bond a film dielectric between two layers of polyester non-woven or Nomex aramid paper, so the sheet folds into a slot without cracking. DMD, NMN, NHN and PMP cover Class B to Class H windings in motors and dry-type transformers.

6641 DMD flexible insulation laminate
6641 DMD flexible laminate — non-woven / PET film / non-woven, 0.10–0.50 mm, slit from 10 mm.
Thermal class
B (130 °C) to H (180 °C)
Total thickness
0.05–0.50 mm
Slit width
10–1000 mm
Reference standard
GB/T 5591.3 · IEC 60371
Laminate range

Laminate constructions

Each construction pairs a film core with an outer paper or non-woven layer. The outer layer decides how the part folds and how much resin it takes up; the film decides the dielectric.

Selection and processing

Selecting and specifying Insulation Flexible Laminates

  • Describe the forming operation. Hand-inserted slot liner, machine-folded phase insulation and wrapped layer insulation pull different total builds, because the fold radius is set by thickness.
  • Set the temperature, then the construction. DMD lands at Class B/F, NMN and NHN at Class H (180 °C), PMP where a capacitor-grade film core is required.
  • Give thickness and width in one message. Total build 0.05–0.50 mm, slit width 10–1000 mm, supplied as roll or cut sheet to your blank size.
  • Name the checks that matter for folded parts. Breakdown voltage, tensile strength, and whether the slit edge must stay burr-free for the inserter.
How ordering works

From laminate specification to batch delivery

  1. 01 Send your specification

    Thickness, width, quantity, thermal class and the drawing or standard you work to.

  2. 02 Construction and thickness confirmed

    Outer layer and film core fixed against your thermal class; total build and slit width set together.

  3. 03 Folded sample approved

    A strip of the exact build is sent to fold on your line before the slit plan and roll length are fixed.

  4. 04 Production and batch test

    Batch run, test report and packing confirmed against the order before dispatch.

1986founded
22production lines
130+countries served
3,000+customers
Certified & audited: UL E310670 IATF 16949 ISO 9001 ISO 14001 CE RoHS REACH CNAS
Questions buyers ask

Flexible laminate questions

Which laminate suits a Class H motor?

NMN (aramid paper / PET film / aramid paper) or NHN, both rated Class H (180 °C) at 0.12–0.50 mm total build. DMD is limited to Class F (155 °C) and should not be specified where the winding is qualified to H.

How tight can the laminate be folded?

The fold radius is governed by total build and by the film core, so it is confirmed on your part rather than from a table. Send the slot corner radius and the thickness you intend to use, and a sample is sent to fold before the tooling is fixed.

Do you supply cut sheets as well as rolls?

Both. Rolls are slit from 10 mm to 1000 mm wide to the length you specify; sheets are cut to your blank size so the liner goes straight into the inserter without a second cut.

Next step

Need a laminate that folds without cracking?

Send the thermal class, total build, slit width and the fold radius of your slot. A sample strip goes out for your trial.

Request a sample