



Paper Insulation Tape
Insulating tape is widely used in electrical work such as wrapping, jointing, insulation sealing and other electrical work for wires used below 380V.
Description
Insulating tape is widely used in electrical work such as wrapping, jointing, insulation sealing and other electrical work for wires used below 380V. The production process has two kinds of glue rubbing method and glue coating method. Production process: It is made of polyvinyl chloride film as the base material and coated with rubber-type pressure-sensitive adhesive. Electrical insulating adhesive tape, commonly known as electrical tape (hereinafter referred to as insulating tape), is a special adhesive tape used for electrical wiring and other insulation. In the past, tape-type insulating adhesive tape was used on electrical circuits, that is, black. Insulating tape, the base tree (back material) is woven cloth soaked with insulating material. With the progress of science and technology and the development of economy, many types of insulating tapes have appeared, but the common ones are: polyvinyl chloride and polyolefin insulating tapes. In the process of using electricity, although people have noticed that the size of the cross-sectional area of the power cord material has an impact on the safe use of electricity, they often do not pay enough attention to the use of insulating tape on the joints. The laying of power lines is becoming more and more complicated, under the wooden floor, in the wall, in the partition, and in the wet ground or in the water. If the insulating tape is used improperly, electric leakage will occur, endangering personal safety. Therefore, we must use insulating tape correctly. The power cord connectors are divided into "+" word connection method, "-" word connection method, and "T" word connection method. The joint should be tightly wrapped, smooth and free of burrs, otherwise, before the thread end is disconnected, it should be lightly pressed with wire cutters, then wound to the pressure opening, and then swung left and right, the thread end will be disconnected at the joint very obediently. If the joint is in a dry place, first wrap 2 layers with insulating black tape, then wrap 2 layers of plastic tape, then use insulating self-adhesive tape to stretch it by about 200%, wrap 2 to 3 layers, and finally wrap 2 layers of plastic tape.
Technical Specifications
|
We Can Do Different Thickness, The Following is for Reference Only
|
|||
|
Part No.
|
PEI13FR/PEI15FR
|
Thickness
|
0.1mm-0.2mm
|
|
Width
|
19mm-1250mm
|
Tensile Strength
|
20N/cm/24N/cm
|
|
Elongation
|
180%/200%
|
Surface
|
Glossy/Matte
|
|
180°Peel Adhesion
|
1.6N/cm
|
Temperature
|
80°C(170°F)
|
|
Voltage
|
600V/3.5KV
|
Flame Retarding Grade
|
Grade1
|
Specifications
|
We Can Do Different Thickness, The Following is for Reference Only
|
|||
|
Part No.
|
PEI13FR/PEI15FR
|
Thickness
|
0.1mm-0.2mm
|
|
Width
|
19mm-1250mm
|
Tensile Strength
|
20N/cm/24N/cm
|
|
Elongation
|
180%/200%
|
Surface
|
Glossy/Matte
|
|
180°Peel Adhesion
|
1.6N/cm
|
Temperature
|
80°C(170°F)
|
|
Voltage
|
600V/3.5KV
|
Flame Retarding Grade
|
Grade1
|


