Vacuum Pressure Impregnation (VPI) is a critical process for achieving high-reliability insulation in medium and high-voltage motor windings. The process replaces trapped air and moisture in winding voids with resin, creating a monolithic insulation system.
Process Steps
1. Pre-heating: The winding is heated to 60-80°C to drive off surface moisture and reduce viscosity for better resin penetration.
2. Vacuum Phase: The winding chamber is evacuated to ≤1 mbar, removing air from all interstices between conductors, slot liners, and phase barriers.
3. Resin Fill: Heated solvent-free epoxy resin is introduced while maintaining vacuum, ensuring deep penetration into the smallest voids.
4. Pressure Phase: Pressure of 2-5 bar is applied for 15-30 minutes, forcing resin into the most difficult-to-reach areas.
5. Drain & Cure: Excess resin is drained, and the winding is cured at 150°C for 2-4 hours, polymerizing the resin into a solid, void-free matrix.
Benefits
VPI treatment improves thermal conductivity by 200-300%, eliminates partial discharge, increases dielectric strength, and provides mechanical rigidity to prevent winding movement during motor starting transients.
